BlacklineSafety 102140, Руководство по установке

Страница: 9 / 16

6
INSTALL LOCATION BEACONS
Before selecting mounting locations for Location Beacons, consider our recommendations below for Location Beacon installation.
INSTALLATION
TRANSMIT POWER SETTINGS
Transmit power level affects the range of Location Beacon’s signals. Beacons are shipped in the lowest transmit power setting level
(Level 2), providing about 15 to 30 feet of coverage. This level is appropriate for most installations.
To physically install Location Beacon:
1. Remove the mounting bracket from
Location Beacon by pressing upward
2. Place the mounting bracket in the
desired mounting location with the
arrow on the inside of the bracket
pointing upward. Mark the position of
two of the mounting holes.
3. Prepare the mounting surface with
pilot holes and the installation of
drywall anchors as appropriate.
DURING INSTALLATION
It is important to record Location
Beacon information as you install
them in your facility for reference
when placing beacons in Blackline
Live. You will want to keep track of
each beacon’s:
• Unit ID
• Installation location
The following worksheet is available
to help you organize this information.
See page 12 of this guide
or download a digital copy
from
support.BlacklineSafety.com
UNIT ID BEACON NAME PLACEMENT LOCATION POWER LEVEL LAYER
LOCATION BEACON INFORMATION
www.BlacklineSafety.com 0021/R5/2017-07-28
BUILDING NAME
PHYSICAL ADDRESS
4. Mount the bracket in place using
the supplied screws
5. Hook Location Beacon on top of
the mounting bracket and snap it
into place
Green Transmit Power Lights – Sets of flashes
Level 5
Level 4 Level 3 Level 2
Lowest Level to Highest Level
To change the transmission power setting on Location Beacon:
1. Press and hold the power/status button. The status light will turn
on and then off. Continue to hold the button, and the status light
will begin to blink in sets of flashes that indicate the power level.
2. Release the button during the desired set of flashes to program
your desired power level. The status light will repeat the
selected power setting 3 times before returning to normal
operating mode.
NOTE:
Location Beacon’s bracket enables
installation on a wall or in a corner.