2
Soldering Iron
Power consumption
70W peak
Temperature range:
200°C - 480°C
Heating Element
Ceramic Heater
Voltage 24V
SPECIFICATIONS
SAFETY PRECAUTIONS
CAUTION: Improper usage can cause serious injury to personnel
and/or damage to equipment. For personnel safety, please follow
these precautions:
●
Check each component after opening the package to make sure everything is in
good condition. Do not use item if visible damage is seen, report the issue to
your vendor.
●
Power off unit and unplug the device when moving the device from one location
to another.
●
Do not subject the main unit to physical shock
- Never drop or sharply jolt the unit.
- Contains delicate parts that may break if the unit is dropped.
●
Always connect power to a grounded receptacle.
●
Tip temperature may reach as high as 480°C when switched ON.
- Do not use the device near flammable materials.
- Do not touch heated parts which may include tips, nozzles, barrels.
●
Disconnect from power source if the unit will not be used for a long periods.
Switch off power during short breaks.
●
Use only genuine replacement parts.
●
Soldering process produces smoke — use on well ventilated place.
●
Do not try to alter or repair unit, bring to qualified service center for repairs.
Specifications are subject to change without prior notice
7
BASIC TROUBLESHOOTING GUIDE
PROBLEM 5: SOLDERING IRON DOES NOT PRODUCE ENOUGH HEAT
Description: Soldering iron cannot melt solder fast enough, or actual tem-
perature does not reach the desired set temperature.
SOLUTION:
The system may need to be recalibrated please
Soldering iron tip may already be too dirty or oxidized .
PROBLEM 6: UNIT PRODUCES ERROR BEEPING SOUNDS
Description: The solder iron produced three being sounds.
SOLUTION:
Soldering iron is not properly connected to its receptacle.
Soldering iron tip is not inserted fully or correctly.