4
SAFETY INSTRUCTIONS
(refer to Figure 1 for location of components)
BEFORE USE
1. Verify that the product and the application are compatible, if in doubt call Blackhawk Automotive Technical
Service (816) 891-6390.
2. Read the operator's manual completely and familiarize yourself thoroughly with the product, its components and
recognize the potential hazards associated with its use
before
using this product.
3. Assemble handle, then secure it in the handle fork with the provided bolt. Open the release valve by turning the
handle counterclockwise (no more than 2 full turns).
4. With saddle fully lowered, locate and remove the oil filler plug. Pump the handle 6 to 8 full strokes. Ensure the oil
level is within ~ 3/16" from the inner cylinder as viewed from the oil filler plug. Reinstall the oil filler plug. Close
release valve by turning the handle clockwise until firm resistance is felt.
5. Check to ensure that jack rolls freely, that the pump and release valve operates smoothly, raises and lowers the
unloaded saddle throughout the advertised lift range before putting into service.
6. Replace worn or damaged parts and assemblies with Blackhawk Replacement Parts only. (See Replacement
Parts Section). Lubricate as instructed in Maintenance Section.
• Study, understand, and follow all instructions
provided with and on this device before use.
• Do not exceed rated capacity.
• Lift only on areas of the vehicle as specified by the
vehicle manufacturer.
• Do not use adapters or accessories that are not
provided initially.
• This is a lifting device only. After lifting, immedi-
ately transfer the load to appropriately rated vehicle
stands.
• Never work on, under, or around a load supported
by this device.
• Use only on hard, level surfaces capable of sus-
taining rated capacity loads.
• Do not move or dolly loads with this device.
• Do not modify this device.
• Failure to heed these markings may result in
personal injury and/or property damage.
ASSEMBLY
Little, if any, assembly is required of these jacks. Always secure the handle into the handle fork by means of the bolt
and lock washer provided. Tighten securely to prevent accidental removal of handle while in use. Familiarize yourself
with the illustrations in the operator's manual. Know your jack and how it operates before attempting to use.
OPERATION
Lifting
1. Place vehicle in park gear, with emergency brake on and wheels securely chocked to prevent inadvertent vehicle
movement.
2. Locate and close release valve by turning handle clockwise, firmly. Center jack saddle under lift point.
3. Verify lift point, then use handle pump to contact lift point. To lift, pump handle until load reaches desired height.
4. Transfer the load immediately to appropriately rated jack stands.
Lowering
1. Raise load high enough to clear the jack stands, then carefully remove jack stands (
always
used in pairs).
To avoid crushing and related injuries:
NEVER work on, under or around a load supported
only by a jack. ALWAYS use adequately rated jack
stands. Immediately transfer the load to adequately
rated jack stands.
!
WARNING
!
WARNING
