TA04724 B Page 4 of 8
CHARGING THE BATTERY
3.1
LED Lamp
Battery
Power Cord
Charger
1.
Connect the power cord to the Charger 144-CHR-LI and to an AC
outlet. The LED Lamp blinks in Red [STAND BY]
NOTE:
The rated input voltage for this unit is 100V-240V. Use of
voltages over 260V will result in damage to the charger.
2. Insert the Battery firmly into the charger.
The LED Lamp lights in green [CHARGING].
NOTE:
Do not short-circuit the Charger by placing foreign materials
in the contacts on Charger, as this will damage the Charger.
3. Charging takes approximately 25 minutes (80% capacity) and
45 minutes (100% capacity).
When charging is finished, the LED Lamp lights in orange
[COMPLETION].
NOTE:
If the LED Lamp displays solid red [HIGH TEMPERATURE],
remove the Battery from the Charger and allow it to cool down
before trying to charge it again.
4. When the battery will no longer charge or hold a charge, the LED
Lamp blinks quickly in red [IMPOSSIBLE TO CHARGE].
5. When the charger is out of order, the LED Lamp does not light up
even if AC power is supplied.
NOTE:
Do not power the Charger with a portable generator.
ATTACHING & DETACHING THE BATTERY PACK
3.2
1. To attach the Battery, slide it into the Battery Adapter at
the rear of the Tool until it stops and the Latches engage.
2. After inserting the Battery, check that it is securely in
place by pulling it gently without pressing the Latches.
3. To detach the Battery, pull out the Battery while pressing
the Latches.
Tool
Battery Adapter
Battery
Slide in
Pull Out
Latches
(both sides)
COMPRESSION CYCLES
3.3
This guide indicates the number of compression cycles that
the TBM14CR-LI can be expected to perform when the
battery is fully charged. These figures are approximate and will
vary according to the charging and other operating conditions,
such as temperature, humidity, and battery condition.
CONDUCTOR
AVERAGE COMPRESSIONS
PER CHARGE
BAT-144-LI
4/0 Cu
120
500 kcmil
100
750 kcmil
60
3.0
OPERATING INSTRUCTIONS
SWITCH OPERATIONS
3.4
1. The ram advances when the Advance Button is
depressed and stops when the Advance Button is
released.
2. To retract the ram, depress the Release Button. The ram
continues to retract while the Release Button is
depressed.
Advance Button
Release Button
