10
Following the ending of a track, the delay
timer can be set to a maximum of 60
minutes and minimum of 5 seconds.
Whilst the unit is in delay mode, the green
status LED will flash. Modes 2, 3, and 4
can use delay.
The Master Volume control is used to set
the maximum volume level. If you do not
use Volume Buttons this will be the
volume set for all users.
However if you do use the dedicated
Volume Button inputs, users will be able
to increase / decrease the volume as they
wish. In this case the Master Volume will
set the maximum volume level users are
able to reach with the Volume Buttons.
We suggest therefore when setting the
Master Volume, you connect Volume
Buttons and use the + button to increase
the volume to the max, then adjust the
Master Volume control accordingly.
The SoundClip will remain at the volume
last set using the Volume Buttons. It will
not reset when powered down / on.
The red LED will be lit when the unit is
powered.
The Green LED is lit when content is
being played. It will also flicker on / off in
1 second intervals when the unit is in
‘Delay Mode’.
Buttons are simply wired directly to the
screw terminals at each of the two inputs.
Pushbuttons work as standard with the
player and are required to be the normally
open ‘push to close’ type.
Piezo, vandal and water-resistant buttons
can be purchased from our online shop if
your installation requires a more robust
switch
Other triggers can be connected such as
a PIR or floor mat switch. If you want to
attach different hardware to the
SoundClip, you need to ensure the device
is compatible or uses optical or
mechanical relays to isolate its circuitry.
The inputs are 5.5V maximum.
