4
www.digiop.com
SECTION 2: INSTALLATION AND SETUP
Camera dome removal
3.
Using the base as a template, mark the location of the three mounting screw holes.
4.
Drill mounting screw holes into the mounting surface:
—
If the mounting surface is a soft material, such as a drywall, drill and install drywall inserts for the mounting screws.
OR
—
If the mounting surface is a very soft material, such as ceiling tile, place a wood block behind the tile and drill holes for
mounting screws long enough to secure the base to the block.
OR
—
If mounting the camera on a hard surface, such as wood, drill the mounting screw holes into the surface before
attaching the camera.
5.
Determine the extension cable routing. If the cable is to be routed through the hole in the bottom of the base, perform the
following steps. If the cable will be routed through the conduit port in the side of the base and routed to a nearby junction
box,
skip to step 9.
6.
While holding the camera in its mounting position, align the mounting screw holes in the base with the holes drilled for the
mounting screws. Mark the location of hole for the extension cable routing.
7.
Drill a 1-3/8” hole through the mounting surface for the extension cable.
8.
If you are routing interface cables through conduit attached to the bottom of the base, do the following:
a.
Unplug the extension cable from the camera electronics and remove it from the camera.