-
1
-
INSTALLATION INSTRUCTIONS
IMPORTANT: Make all wiring connections to the vehicle before connecting the main
10-pin harness and all plug-in connectors to the receiver control
module.
1.
Before mounting the BW-1602 Receiver and Control Module, you must set the PROGRAMMING DIP-
SWITCHES for the kind of operation the customer wants.
These are the switch settings available; Standard (Default) settings are in “BOLD” type:
Switch #1 Door Lock and Unlock Pulse Time: ON = 3/4 seconds. OFF = 3 seconds.
Switch #2 Door Lock and Unlock with ignition: ON = YES. OFF = NO.
Switch #3 Door Locking with Passive Arming: ON = YES. OFF = NO.
Switch #4 Passive or Active Arming: ON = Passive Arming. OFF = Active Arming.
2.
Mount the Receiver and Control Module in a secure area, away from vehicle computers and heating/air condi-
tioning ducts.The location should be convenient for your installation, but well hidden from thieves.Try to mount the unit
as far away from metal objects as possible.This will increase the range of its Remote Control Transmitter.
3.
Route the wires of the harnesses to areas in which the different accessories will be mounted .You may
need to extend some wires. DO NOT plug the wiring harnesses into the Receiver Control Module until
all connections have been completed.
When running the harness wires through the vehicle, be careful to run them where they CANNOT be DAM-
AGED or SHORTED to GROUND or other WIRING. Keep them away from ALL MOVING PARTS of the vehicle
or where HIGH HEAT can damage their insulation.Always protect the harness wires where they pass through
holes in metal panels by using RUBBER GROMMETS.
4.
Mount the MTS-20W Siren under the vehicle’s hood. Mount it away from heat sources such as radiators,
exhaust manifolds, and turbochargers. Mount it in an area where it will not be in the way for mechanics, and so
that it cannot be easily reached from below the vehicle. Mount it so that its opening points down to prevent it
from collecting water, snow, or ice. Connect its BLACK wire to a good clean GROUND point, and its RED wire to
the BROWN wire of the main harness.
5.
Mount the BW-296P Shock Sensor Somewhere inside the vehicle such as under the dash, strapped to the
steering column, or under a seat..
Do Not Mount The Sensor Under The Hood!
Connect the 4-pin harness from the shock sensor to the 4-pin male plug on the circuit board of the Receiver
Control Module.
6.
Mount the BW-180P LED Status Indicator in an easily seen location such as the center of the dash or the
inside top edge of the driver’s or passenger’s door. Connect the RED 2-pin connector from the LED to the RED
2-pin male plug on the circuit board of the Receiver Control Module.
7.
Install the BW-260P Valet/Override Switch in a hidden location that is easily reached by the driver.
Remember that the code learning and valet/override sequence require using this switch in conjunction with the
ignition switch, so it should be hidden, but convenient to use when needed. Connect the BLUE 2-pin connector
from the Override Switch to the BLUE 2-pin male plug on the circuit board of the Receiver Control Module.
8.
Mount the optional BRS-003 Relay Socket and SPDT Relay in a location where it is hidden from poten-
tial thieves. Find the vehicle’s STARTER wire and cut it in half. Connect the colored wires of the Relay Socket as fol-
lows:
BLACK
=
To STARTER wires on Starter side.
YELLOW
=
To STARTER wires on Switch side.
GRAY
=
ORANGE wire of the main harness.
9.
Mount and connect any optional function modules included in the installation, following the mounting and
wiring directions supplied with them.
