3
4
3
4
• Connect the air source hose to the gun. Make sure the air pressure does not
exceed 50 PSI (3.45 BAR).
• Hold the gun perpendicular to the spraying area and then move it parallel several
times.
• The stroke should be started before the trigger is pulled and the trigger should
be released before the stroke is ended. This can control the gun and material.
• Keep the appropriate distance of 6” to 12” between the gun and spraying area,
according to the atomisation pressure and work demand.
note:
To reduce overspray and obtain maximum efficiency, always spray with the
lowest possible atomisation fluid pressure.
adjustment:
The desired pattern, volume of fluid output and fine atomisation can easily be
obtained by tuning the fan adjusting knob, fluid adjusting knob and air adjusting
knob.
type
actIon
result
Fan adjusting knob
Turn right.
Pattern is round.
Turn left.
Pattern is fan.
Fluid adjusting knob
Turn right.
Decrease fluid output.
Turn left.
Increase fluid output.
Air adjusting knob
Turn right.
Decrease air volume.
Turn left.
Increase air volume.
Fan adjusting knob
Fluid adjusting knob
Air adjusting knob
• Wear eye protectIon.
Always wear appropriate eye protection when
operating a spray gun.
• do not over-reach.
Keep proper footing and balance at all times. Do not
reach over or across running machines.
• stay alert.
Watch what you are doing and use common sense. Do not
operate any tools when you are tired.
• check for damaged parts.
Before using any tool, any part that appears
damaged should be carefully checked to determine if it will operate properly
and perform its intended function. Any part that cannot fulfill it’s intended
purpose should be replaced.
• replacement parts and accessorIes.
When servicing, use only
identical replacement parts.
• do not operate tools If under the Influence of alcohol or
drugs.
Read warning labels on prescriptions to determine if your judgement
or reflexes will be impaired while taking drugs. If there is any doubt, do not
operate the tool.
operatIon
preparation before operating:
• Check and replace any damaged or worn parts.
• Make sure the nozzle and air trigger are free to operate correctly.
• Pour paint into the paint cup.
• Attach the cup to the spray gun. Make sure the lid is securely tightened and the
vent tube is secured.
WarnIng:
When filling or refilling the material, disconnect your gun from the air
supply to avoid accidental spillage or spraying.
operating:
recommended air line components
(for best results you should incorporate an
air regulator with filter).
Содержание S-770S
Страница 1: ......
