3
4
• Keep proper footing and balance at all times. If necessary, secure the work
piece in a clamp or vice.
• Keep the spray gun pointed away from your body and from other people in
the work place. Do not direct paint or air at yourself or others.
• Ensure that the spray gun is disconnected from the air supply before
servicing, changing accessories and when not in use.
• do not
allow smoking or open flames in the work area.
• do not
carry the spray gun by the hose.
• do not
tamper with, or adjust, the safety valve.
• do not
use whilst tired or under the influence of drugs, alcohol or
intoxicating medication.
aPPlIcatIons
• Commercial, illustrations, photo retouching, hobby and crafts.
asseMBlY
• Screw one side of the air hose onto the air hose connection of the air brush
and the other end onto the air supply.
• Use the air hose adaptor to connect the air hose to the compressor if
necessary.
oPeratIon
• Fill the cup with fluid after thinning appropriately.
• Hold the air brush lightly in your hand.
• By pressing the main lever down, a stream of air emerges. Then draw it
backward gradually for colour atomisation.
• The spray pattern is in determined by the distance between the work surface
and the air brush.
• For fine line spraying, remove the needle cover and hold the air brush near the
work surface.
• To achieve a consistent output of material the airbrush is equipped with a
“needle stop adjustment screw”. This allows you to draw back the paint flow
to a preset amount which in turn will deliver an even flow for the entire stroke.
Simply adjust the screw to your desired output and test on a piece of scrap
material. Fine tune until the desired flow is achieved and you are set to go.
note:
We recommend you spray on an old newspaper or other material to get
the “feel” of your air brush before approaching your work piece.
cleanIng and MaIntenance
note:
To achieve the best results when spraying it is always best to start with
the air brush clean and totally free from old paint deposits, dirt, etc. Therefore,
the air brush should be thoroughly cleaned immediately after each operation.
WarnIng:
Turn off air and paint to the air brush and release pressure by
triggering the air brush before disassembling, cleaning or servicing. If unsure,
please take the air brush to a qualified technician for repair.
• Empty the fluid cup and wash with thinners (or water depending on the
application).
• Refill with solvent (or water depending on the application), then block the
needle cover with a finger and spray.
• The air flows backward into the nozzle to clean the paint remaining in the air
brush.
