Page 7 — English
ASSEMBLY
To install the vacuum tubes:
Secure the upper and lower vacuum tubes together by
aligning the raised locking tabs with the raised slots.
Tap tube assembly on ground until the screw holes in
lower tube are in the raised slot of the upper tube. Secure
with supplied screws
.
Depress door tab using a flat head screwdriver and open
vacuum inlet door.
Align screw mounts on vacuum opening with screws on
vacuum tube assembly.
Turning clockwise, tighten screws on upper vacuum tube
to secure to blower housing.
To remove the vacuum tubes:
Loosen screws of the upper vacuum tube by turning
counterclockwise.
Remove the vacuum tube assembly from the blower
housing.
Close the vacuum inlet cover door securely.
Remove the vacuum bag by using a flat head screwdriver
to lift the locking tab, rotate to unlock the adaptor and
remove.
INSTALLING THE VACUUM BAG
See Figures 5 - 6.
Remove the nozzle and upper blower tube from the blower
by using a flat head screwdriver to lift the locking tab,
twisting and removing from blower housing outlet.
Unzip the vacuum bag and push the vacuum bag adaptor
through the opening opposite the zipper as shown. The
wider end of the adaptor will remain on the inside of the
vacuum bag when installed properly.
Align the raised slots on the vacuum bag adaptor with the
raised locking tabs on the blower housing outlet. Push
the vacuum bag adaptor onto the housing and twist to
lock into place.
Rotate the vacuum bag until the shoulder strap is upright.
Make sure the vacuum bag is zipped and closed before
starting the unit.
INSTALLING THE VACUUM TUBES
See Figures 7 - 8
.
WARNING:
Contact with rotating impeller blades could result in seri-
ous personal injury. Always stop the engine and ensure
impeller blades have stopped rotating before opening
the vacuum door or installing/changing tubes. Do not put
hands or any other object into the vacuum tubes while
they are installed on the unit.
