B
A
4
Horn
TURBO BEAVER Item code: BH162 Instruction Manual
10
INSTALLING THE CONTROL HORNS AND LINKAGES
1)
Working with the aileron linkage for now, thread
one nylon clevis at least 14 turns onto one of the
2mm x 180mm threaded wires.
2)
Attach the clevis to the outer hole in the control
horn. Install a silicone tube on the clevis.
3)
Locate one nylon servo arm, and using wire
cutters, remove all but one of the arms. Using a
2mm drill bit, enlarge the third hole out from the
center of the arm to accommodate the aileron
pushrod wire.
4)
Plug the aileron servo into the receiver and
center the servo. Install the servo arm onto the
servo. The servo arm should be perpendicular to
the servo and point toward the middle of the wing.
5)
Center the aileron and hold it in place using a
couple of pieces of masking tape.
6)
With the aileron and aileron servo centered,
carefully place a mark on the aileron pushrod wire
where it crosses the hole in the servo arm.
7)
Using pliers, carefully make a 90 degree bend
down at the mark made. Cut off the excess wire,
leaving about 6mm beyond the bend.
8)
Insert the 90 degree bend down through the
hole in the servo arm. Install one nylon snap
keeper over the wire to secure it to the arm. Install
the servo arm retaining screw and remove the
masking tape from the aileron.
9)
Repeat step # 4 - # 8 to install the second
aileron linkage. After both linkages are completed,
connect both of the aileron servo leads using a Y-
harness you have purchased separately.
Bottom view
100mm Push rod
- - 4
Nylon Clevis
- - - 4
Horn
- - - - - - 4
- - - - - - 4
Flaslink
1.7x8mm Cap Screw
- - - - - - - 4
