29
TAYLORCRAFT
- Item code: BH 134
.
Instruction Manual
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape to
hold the foam in place.
3. Position the battery pack and receiver
behind the fuel tank. Use two tie wraps to hold
the battery and receiver securely in place as
pictures below
Do not permanently secure the receiver and
battery until after balancing the model.
4. Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
INSTALLING THE RECEIVER AND BATTERY.
Battery of
engine.
Battery of
receiver.
Receiver
See pictures below:
INSTALLING THE COCKPIT.
A+B Epoxy
PLUS glue.
A+B Epoxy
PLUS glue.
Содержание TAYLORCRAFT BH 134
Страница 17: ...17 TAYLORCRAFT Item code BH 134 Instruction Manual Right side 9 mm 243 mm Bottom side 4x12mm...
Страница 22: ...22 TAYLORCRAFT Item code BH 134 Instruction Manual Drill a hole 2mm Secure Secure...
Страница 31: ...31 TAYLORCRAFT Item code BH 134 Instruction Manual Left side Secure 3x15mm Secure Top side...
