12
SEA FURY -
Item code:BH102
INSTRUCTION MANUAL.
When the stopper assembly is installed in the
tank, the top of the vent tube should rest just
below the top surface of the tank. It should not
touch the top of the tank.
3) Carefully bend the second nylon tube
up at a 45 degree angle (using a cigarette
lighter). This tube will be the vent tube to the
muffler.
INSTALLING THE STOPPER ASSEMBLY
FUEL TANK.
4) Carefully bend the third nylon tube down
at a 45 degree angle (using a cigarette lighter).
This tube will be vent tube to the fueling valve.
1) The stopper has been pre-assembled
at the factory.
2) Using a modeling knife, cut one length
of silicon fuel line (the length of silicon fuel line
is calculated by how the weighted clunk should
rest about 8mm away from the rear of the tank
and move freely inside the tank). Connect one
end of the line to the weighted clunk and the
other end to the nylon pick up tube in the stop-
per.
See pictures below:
INSTALLING THE ENGINE MOUNT.
Bottom side
Drill a hole
3mm diameter
4 x 30 mm
Repeat the procedure for the other wing
half
.