Black Horse Model Sea Fury BH102, Инструкция по эксплуатации

Страница: 13 / 34

13
SEA FURY -
Item code:BH102 INSTRUCTION MANUAL.
5x70mm
INSTALLING THE ENGINE MOUNT.
See pictures below:
Left side
INSTALLING THE STOPPER ASSEMBLY

1) The stopper has been pre-assembled
at the factory.

2) Using a modeling knife, cut one length
of silicon fuel line (the length of silicon fuel line
is calculated by how the weighted clunk should
rest about 8mm away from the rear of the tank
and move freely inside the tank). Connect one
end of the line to the weighted clunk and the
other end to the nylon pick up tube in the stop-
per.
FUEL TANK.
Secure.

3) Carefully bend the second nylon tube
up at a 45 degree angle (using a cigarette
lighter). This tube will be the vent tube to the
muffler.
When the stopper assembly is installed in the
tank, the top of the vent tube should rest just
below the top surface of the tank. It should not
touch the top of the tank.

4) Carefully bend the third nylon tube down
at a 45 degree angle (using a cigarette lighter).
This tube will be vent tube to the fueling valve.
Vent tube
Fuel pick- up tube
Fuel fill tube
Tygon gas tubing not included.

5) Test fit the stopper assembly into the
tank. It may be necessary to remove some of
the flashing around the tank opening using
a modeling knife. If flashing is present, make
sure none of it falls into the tank.