Fuel tank
Instruction manual
RYAN
Item code: BH72
INSTALLING THE RECEIVER & BATTERY
INSTALLING THE SWITCH
<Top side>
S
witch
ON
OFF
1) Plug the servo leads and the switch lead into the
receiver. You may want to plug an aileron extension into
the receiver to make plugging in the aileron servo lead
easier when you are installing the wing. Plug the battery
pack lead into the switch.
2) Wrap the receiver and battery pack in the protective
foam to protect them from vibration. Use a rubber band
or masking tape to hold the foam in place.
Do not permanently secure the receiver and
battery until after balancing the model.
1) The switch should be mounted on the fuselage side,
opposite the muffler, close enough to the receiver so the
lead will reach. Use the face plate of the switch cut out
and locate the mounting holes.
2) Cut out the switch hole using a modeling knife. Use a
2mm drill bit and drill out the two mounting holes
through the fuselage side.
3) Secure the switch in place using the two machine
screws provided with the radio system.
Receiver
Battery
Battery
Zip tie
Zip tie
<Top side>
Must be purchased
separately!
Switch
Foam Pad
Tape
Receiver
34
145mm
