9
PZL-104 Wilga
- Item code: BH 124
.
Instruction Manual
1. Install one adjustable metal connector
through the third hole out from the center of
one servo arm, enlarge the hole in the servo
arm using a 2mm drill bit to accommodate the
servo connector. Remove the excess mate-
rial from the arm.
After installing the adjustable metal con-
nector apply a small drop of thin C/A to the
bottom nut. This will prevent the connec-
tor from loosening during flight.
INSTALLING THE THROTTLE - CABLE.
Throttle servo
Throttle servo
INSTALLING THE STOPPER ASSEMBLY
1) The stopper has been pre-assembled
at the factory.
2) Using a modeling knife, cut one length
of silicon fuel line (the length of silicon fuel
line is calculated by how the weighted clunk
should rest about 8mm away from the rear of
the tank and move freely inside the tank).
Connect one
end of the line to the weighted clunk and the
other end to the nylon pick up tube in the stop-
per.
3) Carefully bend the second nylon tube
up at a 45 degree angle (using a cigarette
lighter). This tube will be the vent tube to the
muffler.
4) Carefully bend the third nylon tube down
at a 45 degree angle (using a cigarette lighter).
This tube will be vent tube to the fueling valve.
Throttle - cable
FUEL TANK.
