P47 - THUNDERBOLT.
INSTRUCTION MANUAL.
7
Control horn.
Aileron servo.
Flap servo.
1. Working with the aileron linkage for
now, thread one clevis onto one of the
threaded wires.
2. Attach the clevis to the outer hole in the
control horn.
3. Plug the aileron servo into the receiver
and center the servo. Install the servo arm onto
the servo. The servo arm should be
perpendicular to the servo and point toward
the middle of the wing.
Cut.
Repeat the procedure for the other
wing half
.
Install Aileron control horn as same as the
way of flap control horn .
INSTALLING THE AILERON
LINKAGES.
4. Locate one nylon servo arm, and using
wire cutters,remove all but one of the arms.
Using a 2mm drill bit, enlarge the third hole
out from the center of the arm to accommo-
date the aileron pushrod wire.
5. Using pliers, carefully make a 90 degree
bend down at the mark made. Cut off the ex-
cess wire, leaving about 4mm beyond the
bend.
Содержание P47 Thunderbolt
