Black Horse Model JU87-STUKA, Инструкция по эксплуатации

Страница: 13 / 34

JU87-STUKA -
Item code: BH80.
INSTRUCTION MANUAL
13
INSTALLING THE STOPPER ASSEMBLY
1. The stopper has been pre-assembled at
the factory.
FUEL TANK.
Vent tube
Fuel pick- up tube
Fuel fill tube
Drill a hole
4mm diameter
2. Using a modeling knife, cut one length of
silicon fuel line (the length of silicon fuel line is
calculated by how the weighted clunk should
rest about 8mm away from the rear of the tank
and move freely inside the tank). Connect one
end of the line to the weighted clunk and the
other end to the nylon pick up tube in the stop-
per.
5. Test fit the stopper assembly into the
tank. It may be necessary to remove some of
the flashing around the tank opening using
a modeling knife. If flashing is present, make
sure none of it falls into the tank.
3. Carefully bend the second nylon tube up
at a 45 degree angle (using a cigarette lighter).
This tube will be the vent tube to the muffler.
4. Carefully bend the third nylon tube down
at a 45 degree angle (using a cigarette lighter).
This tube will be vent tube to the fueling valve.
When the stopper assembly is installed
in the tank, the top of the vent tube should
rest just below the top surface of the tank.
It should not touch the top of the tank.