19
HARMON ROCKET
- Item code: BH100
.
Instruction Manual
2. Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
Secure.
Elevator
pushrod.
Rudder
pushrod.
Bottom side.
1. Cut out the switch hole using a modeling
knife. Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
2. Secure the switch in place using the
two machine screws provided with the radio
system.
INSTALLING THE SWITCH.
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape to
hold the foam in place.
Switch
of Engine
INSTALLING THE RECEIVER AND BATTERY.
Switch
Do not permanently secure the receiver and
battery until after balancing the model.
3. Position the battery pack and receiver
behind the fuel tank. Use two tie wraps to hold
the battery and receiver securely in place as
pictures below
Tie wrap.
