EDGE 540-V3-
ITEM CODE: BH91
.
Instruction Manual
14
Cut.
Throttle servo
PARTS REQUIRED
1) Assemble and mounting the wheel pants
as shown in the following pictures.
INSTALLING THE MAIN LANDING GEAR.
4 x 20 mm
Secure.
INSTALLING THE SPINNER.
Install the spinner backplate, propeller and
spinner cone. The spinner cone is held in
place using two 3mm x 12mm wood screws.
3 x 15mm
1. Install one adjustable metal connector
through the third hole out from the center of
one servo arm, enlarge the hole in the servo
arm using a 2mm drill bit to accommodate the
servo connector. Remove the excess mate-
rial from the arm.
INSTALLING THE THROTTLE PUSHROD.
After installing the adjustable metal con-
nector apply a small drop of thin C/A to
the bottom nut. This will prevent the con-
nector from loosening during flight.
Throttle servo
Throttle pushrod.
Servo arm.
Connector.
Connector.
Secure
