3. INSTALLING THE CONTROL HORNS, LINKAGES
* Attach the clevis to the outer hole in the servo
arm. Install a silicone tube on the clevis.
*
Using pliers, carefully make a 90 degree bend
down at the mark made. Cut off the excess wire,
leaving about 6mm beyond the blend.
After both linkages are completed. connect both of
the aileron servo loads using a Y-harness you have
purchased.
Insert the 90 degree bend down through the hole in the
control horn. Install one nylon snap keeper over the
wire to secure it to the control horn. Install the control
horn retaining screw and remove the masking tape
from the aileron.
Repeat the procedure to install the other wing.
A+B
glue
Epoxy
Control horn
Flaslink
Pushrod wire
Horn
Bend and cut.
Silicone Tube
M2
2mm Nut
100mm Push rod
- - 4
- - - 4
- - 4
- - - - -
Horn
- - - 4
- - 4
Flaslink
- - - - - 4
5mm Silicone Tube
Servo arm
Silicone Tube
. Item code: BH163
DORNIER DO335
6
3mm Washer
- - - - - - - 8
3 x 15mm Cap Screw
- - 8
- - - - -
3 x 12mm Screw
- - - - - - 7
3mm Spring Washer
- - - - - - - 8
3x15mm
Secure
4. INSTALLING THE ELECTRIC MOTOR, COWLING
