EDGE 540-V3 -
Item code: BH93.
Instruction Manual
4
REPLACEMENT SMALL PARTS
1. Install the rubber grommets and brass
eyelets onto the aileron servo.
INSTALLING THE AILERON SERVOS 1.
I. SERVO
4. Wheels.
3. Wheel pant.
1. Aluminium landing gear.
2. Plastic parts for landing gear.
5. Plastic parts for rudder pushrod.
6. Rudder plastic light.
9. Fuel Tank.
8. Tail gear set.
7. Spinner.
2. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into ai-
leron servo tray as same as picture below.
1. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
3. Instal servo tray with aileron servo into
the wing as same as picture below.
Electric
wire.
Thread.
Bottom side.
1.
3.
1.
4.
6.
2.
3.
7.
8.
5.
9.
