THUNDERBIRDS Item code: BH144-A
.
Instruction Manual
3
Wing warp:
Hold the panel twisted gently in
the opposite direction to the warp,
and apply warm air to remove the
creases from the covering.
Caution! do not heat the lm more than is absolutely
necessary. If the air or the iron is too hot, the lm may
melt and holes may be formed.
This model is highly pre-fabricated and can be built
in a very short time. However, the work which you
have to carry out is important and must be done
carefully. The model will only be strong and y well
if you complete your tasks competently - so please
work slowly and accurately.
When self-tapping screws have to be screwed
into wood, apply a little white glue to prevent
them shaking loose: just squirt white glue into
the hole and t the screw.
Caution:
This model is not a toy!
If you are a beginner to this type of powered model,
please ask an experienced model yer for help and
support. If you attempt to operate the model without
knowing what you are doing you could easily injure
yourself or somebody else. Please keep your safety
and well-being in mind at all times.
Important:
Before you start construction
Even if you have built a large number of RC models
please read right through these instructions and
check all the kit components against the parts list.
We have taken great trouble to keep construction as
simple as possible, without making any compromises
in the area of safety.
Note regarding the lm covering
Minor creases or bubbles may develop in the
lm covering due to major uctuations in weather
conditions (temperature, humidity etc.); in rare cases
you may even nd a slight warp in a component.
These minor faults are in the nature of lm-covered
built-up wooden structures, and can easily be
corrected using a heat gun, as commonly used for
modelling.
Creases:
Blow warm air over the area and
rub down with a soft cloth.
+ This is not a toy
+ Be sure that no other yers are using your radio
frequency.
+ Wear safety glasses.
+ The glow plug clip must be securely attached to
the glow plug.
+ Do not start the EDF if people are near.
SAFETY PRECAUTION
REPLACEMENT LARGE PARTS
A: Fuselage.
B: Wing panels. (B1,B2)
C: Plastic bomb top wing. (C1,C2)
D: Horizontal stabilizer (D1,D2)
E: Vertical stabilizer.
F1: Aluminium tube wing dihedral brace
F2: Aluminium tube horizontal stabilizer.
G: Decal sheet
L: Cockpit fuselage (L1, L2. L3).
B1
C1
C2
B2
D1
D2
A
F
E
G
F1
F2
L
L3
L2
L1
