THUNDERBIRDS Item code: BH144-A
.
Instruction Manual
2
This instruction manual is designed to help you build a great ying aeroplane. Please read this manual
thoroughly before starting assembly of your
THUNDERBIRDS
. Use the parts listing below to identify all parts.
FUSELAGE ASSEMBLY
1
(1) Fuselage.
WING ASSEMBLY
1
(1) Right wing half with pre-installed
aileron.
1
(1) Left wing half with pre-installed
aileron.
TAIL SECTION ASSEMBLY
1
(1) Vertical stabilizer with pre-installed
rudder.
1
(1) Horizontal stabilizer with
pre-installed elevator halves.
1
Some more parts.
1
HARDWARE PACK
1
Landing gear.....
Please trial t all the parts. Make sure you have
the correct parts and that they t and are aligned
properly before gluing! This will assure proper
assembly.
THUNDERBIRDS
ARF is hand made
from natural materials, every plane is unique
and minor adjustments may have to be made.
However, you should find the fit superior and
assembly simple.
The painted and plastic parts used in this kit are
fuel proof. However, they are not tolerant of many
harsh chemicals including the following: paint
thinner, C/A glue accelerator, C/A glue debonder
and acetone. Do not let these chemicals come in
contact with the colors on the covering and the
plastic parts.
To avoid scratching your new airplane, do not
unwrap the pieces until they are needed for
assembly. Cover your workbench with an old towel
or brown paper, both to protect the aircraft and to
protect the table. Keep a couple of jars or bowls
handy to hold the small parts after you open the
bag.
SUGGESTION
NOTE
Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is capable
of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU ASSUME ALL
RISK & RESPONSIBILITY.
If you are inexperienced with basic R/C ight we strongly recommend you contact your R/C supplier
and join your local R/C Model Flying Club. R/C Model Flying Clubs offer a variety of training procedures
designed to help the new pilot on his way to successful R/C ight. They will also be able to advise on any
insurance and safety regulations that may apply.
WARNING
1
Thick cyanoacrylate glue.
1
30 minute epoxy.
1
5 minute epoxy.
1
Hand or electric drill.
1
Assorted drill bits.
1
Modelling knife.
1
Straight edge ruler.
1
2mm ball driver.
1
Phillips head screwdriver.
1
220 grit sandpaper.
1
90° square or builder’s triangle.
1
Wire cutters.
1
Masking tape & T-pins.
1
Thread-lock.
1
Paper towels.
TOOLS & SUPPLIES NEEDED
PARTS LISTING
