TROJAN.
INSTRUCTION MANUAL
25
Cut
Nose gear pushrod
Rudder pushrod
1. Install one adjustable metal connector
through the third hole out from the center of
one servo arm, enlarge the hole in the servo
arm using a 2mm drill bit to accommodate the
servo connector. Remove the excess material
from the arm.
After installing the adjustable metal con-
nector apply a small drop of thin C/A to
the bottom nut. This will prevent the con-
nector from loosening during flight.
INSTALLING THE THROTTLE PUSHROD.
Secure
Cut
Throttle pushrod
2. Secure the switch in place using the
two machine screws provided with the radio
system.
1. Cut out the switch hole using a modeling
knife. Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
INSTALLING THE SWITCH.
Servo arm.
Connector.
