Black Horce Model SUKHOI31, Инструкция по эксплуатации

Страница: 19 / 27

SUKHOI 31.
INSTRUCTION MANUAL
19
6) When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the verti-
cal stabilizer mounting area. Apply epoxy to
the lower rudder hinge. Set the stabilizer in
place and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a
paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceed-
ing.
Epoxy glue.
Epoxy glue.
RUDDER CONTROL HORN INSTALLA-
TION.
Rudder control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
Drill 6mm a hole of the mounting rudder
control horn on to the rudder with 6mm diam-
eter.
Control horn of Rudder.
C/A glue.
Pen.
Mark a hole.
3mm x 40mm.
M3 lock nut
.
Nilon
control clasp.