5
SKY JET -
Item code: BH144
.
INSTRUCTION MANUAL
1) Install the rubber grommets and brass
eyelets onto the aileron servos.
4. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into ai-
leron servo tray as same as picture below.
3) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
I. AILERON.
1.INSTALLING THE AILERON SERVOS.
Secure.
Cut the covering
away from the slot.
Temporary pin to
keep hinge centered.
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Bottom side
2. Using a modeling knife, remove the cov-
ering servo tray.
Aileron
Flap
Bottom side
Servo tray.
