19
L-13 BLANIK - Item code: BH135
.
Instruction Manual
3. Position the battery pack and receiver
is as picture below.
Do not permanently secure the receiver and
battery until after balancing the model.
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
INSTALLING THE RECEIVER AND BATTERY.
4. Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape
to hold the foam in place.
Right side.
C/A glue.
Left side.
Battery of motor.
Receiver
.
WING ATTACHMENT.
1.Locate the aluminium wing dihedral
brace.
*** Test fit the aluminium tube dihedral brace
into each wing haft. The brace should slide in
easily. If not, use 220 grit sand around the
edges and ends of the brace until it fits prop-
erly.
Aluminium tube 19mm
870mm
714mm
25mm
Battery of receiver .
UBEC.
