FAIREY ALBACORE
Item code: BH166
High Wing
Bottom view
2x10mm
Low Wing
Bottom view
2x10mm
2x10mm
2 x 10mm Screw
- - - - 16
3. INSTALLING THE CONTROL HORNS, LINKAGES
* Attach the clevis to the outer hole in the servo arm.
*
Using pliers, carefully make a 90 degree bend down
at the mark made. Cut off the excess wire, leaving
about 6mm beyond the blend.
After both linkages are completed. connect both of
the aileron servo loads using a Y-harness you have
purchased.
Insert the 90 degree bend down through the hole in the
control horn. Install one nylon snap keeper over the
wire to secure it to the control horn. Install the control
horn retaining screw and remove the masking tape
from the aileron.
A+B
glue
Epoxy
Control horn
Flaslink
Pushrod wire
Horn
Bend and cut.
Silicone Tube
100mm Push rod
- 4
M2
- - - 4
2mm Nut
- 4
- - - - - -
Horn
- - - - - - - - 4
- - - - - - 4
Flaslink
Silicone Tube
Servo arm
Cut
Silicone tube
5mm
6
