14
EDGE -
Item code: BH69-A
.
Instruction Manual
1. Draw a center line onto the horizontal
stabilizer. Then put the horizontal into the fuse
large.
2 Using a modeling knife, cut away the cov-
ering from the fuselage for the stabilizer and
remove it.
Drill a hole
1.5mm
3. Mark the shape of the vertical on the left
and right sides onto the horizontal stabilizer
using a felt-tip pen
Elevator control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
Elevator
control horn
Bottom side
A+B Epoxy
PLUS glue.
Top side
Control horn of elevator.
ELEVATOR CONTROL HORN
INSTALLATION.
center line
Check to mark sure the wing and stabi-
lizer are paralell. If they are not, lightly sand
the opening in the fuselage for the stabilizer
until the stabilizer is paralell to the wing.
