DIABLO Instruction Manual.
1 0
COWLING.
1).Slide the fiberglass cowl over the en-
gine and line up the back edge of the cowl with
the marks you made on the fuselage.
Pushrod wire.
4) Install the muffler and muffler extension
onto the engine and make the cutout in the
cowl for muffler clearance. Connect the fuel
and pressure lines to the carburetor, muffler
and fuel filler valve.
3) Slide the cowl back over the engine and
secure it in place using four wood screws.See
picture below.
Trim and cut.
3x10mm.
2) While keeping the back edge of the cowl
flush with the marks, align the front of the cowl
with the crankshaft of the engine. The front of
the cowl should be positioned so the crank-
shaft is in
nearly
the middle of the cowl open-
ing. Hold the cowl firmly in place using pieces
of masking tape.
