4. Set up instructions
Read the entire important safety information section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
To prevent serious injury from accidental starting: Turn the power switch of
the equipment to its “OFF” position, wait for the engine to cool before assembling or making any
adjustments to the equipment.
To prevent serious injury: Operate only with proper spark arrestor installed.
Operation of this equipment may create sparks that can start fires around dry vegetation. A spark
arrestor may be required. The operator should contact local fire agencies for laws or regulations
relating to fire prevention requirements.
Note:
For additional information regarding the parts listed in the following pages, refer to the Assembly
Diagram near the end of this manual.
A. Location
1. The Generator must be installed outdoors where ventilation is readily available.
2. Install the Generator so that the air inlets and outlets are not blocked by obstructions such as bushes,
trees, or snow drifts. Locating it in the path of heavy winds or snowdrifts may require the placement of
5
a barrier for protection. The air inlet should face the prevailing wind direction.
3. Install the Generator on a concrete slab or other area where water can not reach it.
4. Generator placement should allow four feet of access on all sides for maintenance.
5. Place the Generator as close as possible to the electrical tools and equipment being powered to
reduce the length of extension cords.
B. Grounding
1. Connect a #12 AWG grounding wire (not included) from the Grounding Point on the Generator to a
grounding rod (not included) that has been driven at least 24 inches into the ground. The grounding rod
must be a copper or brass rod which can adequately ground the Generator. Only a trained and
licensed electrician should perform this procedure.
grounding point
2. Electrical and other permits may be required for the installation of emergency power systems.
Investigate local building and electrical codes before installing this unit. Installation must be completed
by a licensed contractor.
