English
11
Reload nylon line (either bulk or prewound replacement
spool) as shown in this manual.
• USE ONLY .080 inch (2.032 mm) DIAMETER ROUND
NYLON MONOFILAMENT LINE. Do not use serrated or
heavier gauge line, as they will overload the motor and
cause overheating. This line is available at your local
dealer or authorized service center. Do not use lighter
gauge line, as it may not feed properly.
• Other replacement parts (guards, spool caps, etc.) are
available through BLACK+DECKER service centers. To
find your local service location call: 1-800-544-6986 or
visit www.blackanddecker.com.
WARNING:
THE USE OF ANY ACCESSORY
NOT RECOMMENDED BY BLACK+DECKER FOR USE
WITH THIS APPLIANCE COULD BE HAZARDOUS.
Rewinding spool from bulk line (use only
.080 in. round diameter line)
Do not use square, star or other shaped line or other diameters.
These may cause feeding issues or overload the motor.
Bulk line is also available for purchase from your local retailer.
nOTE:
Hand wound spools from bulk line are likely to
become tangled more frequently than BLACK+DECKER
factory wound spools. For best results, factory wound spools
are recommended.
To install bulk line, follow the steps below:
1. Remove battery from appliance.
2. Remove the empty spool from the appliance as
described in “Replacing the spool.”
3. Remove any remaining cutting line from the spool.
4. First, wind new line in the channel of the spool closest
to the holding slots
34
as shown in Figure R.
Figure R
5. Place the end of the cutting line
33
into the retaining
hole
36
(Figure S).
6. Wind the cutting line onto the spool in the direction
of the arrow on the bottom of the spool. Make sure to
wind the line on neatly and in layers. Do not crisscross.
Figure S
36
32
Figure P
31
30
4. Before placing a new spool, "park" the cutting line
33
in the holding slots
34
.
5. Feed the end of each line through the two holes
35
on
either side of the the spool cap
31
as shown in figure Q
6. Slide the spool back into the spool cap. Take care to
keep the line from becoming trapped under the spool.
7. Pull slack line through until it pulls out of the holding
slots.
8. Align the tabs on the spool cap with the slots in the
housing (figure Q).
9. Push the cap onto the housing until it snaps securely
into place.
Figure Q
34
33
35
nOTE:
Make sure that cap is fully positioned, listen for two
audible clicks to ensure both lugs are correctly located.
Power the appliance on. In a few seconds or less you’ll hear
the nylon line being cut automatically to the proper length.
CAUTION:
To avoid appliance damage, if
the cutting line protrudes beyond the trimming blade,
cut it off so that it just reaches the blade.
nOTE:
Other replacement parts (guards, spool caps, etc.)
are available through BLACK+DECKER service centers. To
find your local service location call:
1-800-544-6986
or visit
www.blackanddecker.com
.
WARNING:
The use of any accessory not
recommended by BLACK+DECKER for use with this
appliance could be hazardous.
Replacement accessories
CAUTION:
Before you begin trimming, only
use the appropriate type of cutting line.
EasY
FEED
TM
uses dual line, 0.080” AFS compatible
accessories. Use BLACK+DECKER Model No. EFD-080
replacement spool and DLRC-080 replacement spool cap.
Содержание LST560
Страница 47: ......
