Black+Decker EVO185H2, Руководство пользователя

Страница: 7 / 16

7
ENGLISH (Original instructions)
Electrical safety
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not store in locations where the temperature may
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
40 °C.
Charge only using the charger provided with the tool.
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
p
Do not attempt to charge damaged batteries.
Chargers
Use your Black + Decker charger only to charge the bat-
tery in the tool with which it was supplied. Other batteries
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black + Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
3. Head release button
4. Bit holder
5. Battery
7. Hammer drill head
10. LED work light
11. Charging indicator
12. Charger
13. Speed selector
14. Clutch marking
Assembly
Warning! Before assembly, remove the battery from the tool.
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
the same time pulling the battery out of the receptacle.
Warning!
heads. Moving parts may become hot during use.
the centre position.
To remove a tool head, depress the head release button
(3) and take the head off the tool.
push it onto the tool until it snaps into place.
Fitting and removing a drill bit or screwdriver bit
allow for an easy exchange of bits.
the centre position.
one hand while holding the rear part with the other.
clockwise with one hand while holding the rear part with
the other.
To remove the screwdriver bit from the bit holder, lift the bit
from the recess.