Black+Decker EVO185, Оригинальное руководство пользователя

Страница: 7 / 17

7
ENGLISH (Original instructions)
7
ENGLISH (Original instructions)
u
Charge only at ambient temperatures between 10 °C and
40 °C.
u
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
p
Do not attempt to charge damaged batteries.
Chargers
u
Use your Black + Decker charger only to charge the bat-
tery in the tool with which it was supplied. Other batteries
could burst, causing personal injury and damage.
u
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
u
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black + Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Head release button
4. Bit holder
5. Battery
6. Battery release button
7. Hammer drill head
8. Torque adjustment collar
9. Chuck
10. LED work light
11. Charging indicator
12. Charger
13. Speed selector
14. Clutch marking
Assembly
Warning! Before assembly, remove the battery from the tool.
Fitting and removing the battery (fig. A)
u
To fit the battery (5), line it up with the receptacle on the
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
u
To remove the battery, push the release button (6) while at
the same time pulling the battery out of the receptacle.
Fitting and removing tool heads (fig. B)
Warning! Care must be taken when fitting and removing
heads. Moving parts may become hot during use.
u
Lock the tool by setting the forward/reverse slider (2) to
the centre position.
u
To remove a tool head, depress the head release button
(3) and take the head off the tool.
u
To fit a tool head, line it up with the tool as shown and
push it onto the tool until it snaps into place.
Fitting and removing a drill bit or screwdriver bit
The drill/screwdriver head is fitted with a keyless chuck to
allow for an easy exchange of bits.
u
Lock the tool by setting the forward/reverse slider (2) to
the centre position.
u
Open the chuck (9) by turning the front part clockwise with
one hand while holding the rear part with the other.
u
Insert the bit shaft into the chuck (9).
u
Firmly tighten the chuck (9) by turning the front part anti-
clockwise with one hand while holding the rear part with
the other.
u
To remove the screwdriver bit from the bit holder, lift the bit
from the recess.
u
To store the screwdriver bit, firmly push it into the holder.
Use
Warning! Let the tool work at its own pace. Do not overload.
Warning! Before drilling into walls, floors or ceilings, check for
the location of wiring and pipes.
Charging the battery (fig. C)
The battery needs to be charged before first use and whenev -
er it fails to produce sufficient power on jobs that were easily
done before. The battery may become warm while charging;
this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tem-
perature: approx. 24 °C.
Note: The charger will not charge a battery if the cell