Black+Decker BPD8B, Инструкция по эксплуатации

Страница: 11 / 100

Page 11
SET UP & USE
IMPORTANT!
1. Once you open the water supply line, (even if it is closed immediately thereafter),
the inlet hose will be pressurized.
2. To relieve water pressure from inside the inlet hose, (make sure the water line
(faucet) is closed): press and hold the red pressure relief button on the quick
connect until the flow of water stops.
NOTE:
Hard water conditions will adversely affect the washing performance of
your dishwasher. Hard water conditions will also contribute to ‘lime’ (white
film substance) deposits and/or ‘scaling’ on the stainless steel surface of
the dishwasher tub and heater element, located in the sump underneath
the removable filter screen. To assist in minimizing these conditions, it is
recommended to periodically operate/rinse the inside of the dishwasher
(empty) using 1 cup of white vinegar at least once a week.
DISCONNECTING YOUR DISHWASHER
1. Shut off the water supply at the faucet.
2. Disconnect the power supply cord.
START OF DISHWASHER
The following things should be checked before starting the dishwasher:
1. The dishwasher is level and fixed properly.
2. The inlet valve is open.
3. There is a leakage at the connections of the connectors.
4. The wires are tightly connected.
5. The power is switched on.
6. The inlet and drain hoses are not knotted.
7. All packing materials and printings should no be taken out from the dishwasher.
WARNING: FAILURE TO RELIEVE WATER PRESSURE, BEFORE
DISCONNECTING THE QUICK-CONNECT FROM THE FAUCET, WILL
RESULT IN BACK-PRESSURE OVER-SPRAY. THE TEMPERATURE
OF INCOMING WATER CAN BE VERY HOT, AND BACK-PRESSURE
OVER-SPRAY COULD CAUSE SEVERE BURNS AND/OR SCALDING.
DANGER:
DO NOT LET CHILDREN DISCONNECT THE DISHWASHER; CLOSE
SUPERVISION OF CHILDREN IS ALWAYS IMPORTANT AROUND
APPLIANCES.