ENGLISH
ENGLISH
P. 9
P. 10
INSTALLATION GUIDE
Installing and Removing Side Brush:
To install:
Press the brush directly onto the holder.(Fig. 1)
To remove:
Hold two opposite sides of the brush as shown in Fig. 2, and evenly pull upward
to remove the brush.
Recharging Battery:
1. Before charging, please check if the battery is properly mounted and
turn on the power
switch
.
2. Two ways to charge the battery:
A. Push the adaptor plug into d.c. jack at the side of the unit first, and then plug the a.c. end
of the adaptor into the a.c. power outlet on the wall. (Please connect the adaptor to the
unit first before connecting to the a.c. power outlet.)
Fig. 1
PRESS
CLICK!
Side brush
holder
Adaptor
Plug
D.C. jack
Fig. 2
PULL UP!
B. Make sure the docking station is installed properly, place the unit to the docking station,
make sure the contact points at the back of the unit is contacted with the contact plate at
the docking station. (See dock it the page no.XX needs update proof test)
3. When charging, the LED indicator below the " " (Power) on V660 (as above diagram)
will flash green, and it will stay green when the cleaner has been uninterruptedly charged
for 4~6 hours.
4. To make sure the battery always at full charged status, the unit will be charged 15 min every
hour after full.
5. When the V660 is in the "Battery Low" situation, "
" (Power) will stay in the RED.
