NOTE:
When installing the door sensor, door sensor deputy body must be installed on the bulge side of the door
sensor main body.
Battery Installation
Disassemble the door sensor Install battery, assemble the door main body .
Advice:
1. When the door is closed, and the distance between the main body and the deputy
is less than 2cm, the alarm gateway displays the door is closed perfectly.
2. When the door is opened, the distance between the main body and the deputy
body is more than 2cm, LED light flash and door sensor sends messages to the
alarm gateway, the alarm gateway displays the door is open and alarms.
3.Valid distance of door sensor is 2cm, so when install, please pay attention to the
trigger surface, it is triggered by point to point.
4. Make sure of that door sensor is in the alarm gateway’s network.
The status of LED.
1. When the door sensor is triggered, LED light flashes red once.
2. When the door sensor installs battery, LED light will flash red 5 times.
3. Triple click the code button, add the door sensor to the Z-WAVE network or delete door sensor from Z-
WAVE network , LED light flashes red 5 times.
4. Press on the code button for 10 seconds, the door sensor will be restored to factory default settings, LED
light flashes red once.
5. In the normal condition, the LED light is not illuminated.
Associations
This has the effect that when the sensor is triggered, all devices associated with the sensor will receive the
relevant reports. Through an association the sensor may control another Z-Wave network devices, e.g. the
alarm device, wall plug, lamp etc.
The Door Sensor supports two groups:
Group 1
is assigned to the device status - sending the BASIC SET control frame to the associated devices having
detected motion.
Group 2
reports relay's status to just one device, Z-Wave network's main controller by default. It's not
recommended to modify settings of this association
NOTE:
