MULTIPORT DIGITAL VOIP ROUTER
5
3. Configuring the desired IP address
3.1 Factory-default IP settings
The factory default configuration for the Ethernet interface IP addresses and net-
masks are listed in
table 1
. Both Ethernet interfaces are activated upon power-up.
LAN interface
ETH 0/1 (LAN)
provides a default DHCP server. The WAN inter-
face uses DHCP client to get the IP address and netmask automatically from the
service provider.
If these addresses match with those of your network, go to section “Connecting
the VOE210 to the network” on page 7. Otherwise, continue with the following
sections to change the addresses and network masks.
3.2 Login
1. To access the VOE210, start the Telnet application on your PC. Type the
default IP address into the address field:
192.168.1.1
. Accessing your
VOE210 via a Telnet session displays the login screen. Type the factory
default login:
administrator
and leave the password empty. Press the
Enter
key after the password prompt.
login:
administrator
password:<Enter>
192.168.1.1>
2. After you log in, your VOE210 will be running in operator execution mode
(indicated by > character in the command line prompt). To enter configura-
tion mode, use the commands
enable
and
configure
.
192.168.1.1>
enable
192.168.1.1#
configure
192.168.1.1(cfg)#
Table 1:
Factory default IP address and network mask configuration
Item
IP Addresss
Network Mask
WAN interface Ethernet 0
(ETH 0/0)
DHCP
DHCP
LAN interface Ethernet 1
(ETH 0/1)
192.168.1.1
255.255.255.0
DHCP server address range
(LAN)
192.168.1.10-
192.168.1.19
255.255.255.0
