Bootloader
35
VOE102 Getting Started Guide
4 • VOE initial configuration
Load a new application image (VOE Firmware) via the serial link
The Bootloader supports the ‘X-Modem’ and ‘Y-Modem’ protocols to download application images via the
serial link of the console. Do the following to initiate the download:
Note
This type of download takes about 25 minutes since it uses a serial link at
only 9600 bps.
Step
Command
Purpose
1
RedBoot> load -r -v -m {
xmodem | ymodem } -b
base_address
Downloads an application image into the volatile memory
(RAM) from where the VOE could directly execute it.
‘xmodem’ or ‘ymodem’: Specify the protocol to be used, X-
Modem or Y-Modem
base_address: memory location where to store the application
image. Use the default address 0x1800100
Execute the above RedBoot command first, then start the trans-
fer from the terminal program with the command ‘Send file via
X-Modem’ (or similar).
5
RedBoot> fis delete -n
1
Deletes the first application image.
Reply with ‘y’ to the confirmation request.
6
RedBoot> fis create
Stores the downloaded application image to the permanent
memory (flash:).
Reply with ‘y’ to the confirmation request.
7
RedBoot> fis list -l
Checks whether the image has been successfully stored,
whether it is the desired Release and Build, and whether it is
valid.
8
RedBoot> go
Starts the application image that was downloaded to the vola-
tile memory (RAM).
Содержание VOE102
Страница 40: ...40 Appendix B Cabling Chapter contents Introduction 42 Ethernet 42 ISDN BRI 43 ...
Страница 43: ...43 Appendix C Port pin outs Chapter contents Introduction 45 Ethernet 45 ISDN BRI Terminal NT Net port 45 ...
Страница 45: ...45 Appendix D VOE factory configuration Chapter contents Introduction 47 ...
