21
CHAPTER 3: Quick Start
b) Switch outlet off: To power the switched AC outlet Off, go to the IPS>
command prompt, type
/OFF 1
, and press
Enter
. Power to the switched
outlet will be switched off.
c) Switch outlet on: To power the switched AC outlet On, go to the IPS>
command prompt, type
/ON 1
, and press
Enter
. Power to the switched
outlet will be switched on.
3. Exit command mode: After you finish testing the IPS, type
/X
and press
Enter
to exit from the command mode.
NOTE
Always disconnect using the /X command.
If the /X command is not invoked at the end of a command session, then the
IPS will not exit from command mode until the no activity timeout feature
closes the session. In this case, further access to the IPS command mode may
not be allowed until the current session times out.
This completes the introductory overview of the IPS. Go to
Chapters 4
and
5
for
complete installation and configuration procedures.
