Black Box SWI030A, Руководство пользователя

Страница: 18 / 32

16
POW-R-SWITCHES 1M, 1S
3.5 Making the Power Connections
The next step is to plug in all power cords and power up the system.
1. Plug the AC-powered device that you want to switch into the AC outlet
on the rear panel of the Pow-R-Switch 1M or 1S. Repeat this step for
every device/Switch pair in your system.
NOTE
The total load on each Switch must not exceed 10 amps.
2.
230-VAC versions of the Pow-R-Switches 1M and 1S (product codes SWI030AE
and SWI031AE) only:
Plug the outlet ends of country-specific power cords
(not included) into the Switches’ IEC 320 male inlets.
3. Plug the Switches’ power cords into a working AC outlet.
4. Make certain that any power switches on any of the devices you’ll be
switching are set to the “ON” position. All of the devices you’ll be
switching should now be powered up and operating.
3.6 Testing for Proper Installation
Lastly, you should perform the following test to make certain the Pow-R-
Switch 1M and all of the Pow-R-Switches 1S are operating correctly.
1. Establish a connection with the Pow-R-Switch 1M.
a) If your PC or other control device will be communicating with the
Pow-R-Switch 1M across a modem link,
make sure the modem directly
connected to the Pow-R-Switch 1M’s Control Port is set to the same
data rate as the Switch (see
Section 3.2 ). The modem should also be
set to receive 8 data bits and no parity.
When both modems are ready to go, start your terminal-emulation
software and dial the number for the modem connected to the Pow-
R-Switch 1M. After approximately eight seconds, the Pow-R-Switch 1M
should send the “PRS READY” message.