Black Box MT1100A, Руководство пользователя

Страница: 13 / 26

Chapter 2 Installation and Setup
Configuring Standalone Unit 2-5
Closing the Case
After completing the internal settings, close the unit case.
To close the case:
1. Position the lower half of the case on the flat surface.
2. Install the top cover making sure the top cover guides enter the corresponding
recesses at the end of the unit.
3. Secure the two screws located at the end of the unit.
4. Fit the inside tabs of the blue side panel into the unit case grooves, and slide
the side panel until snaps into place.
Connecting the Interfaces
Connecting the E1 Line
E1 link interface terminates in balanced and unbalanced connectors, marked
LINK.
To connect the balanced interface:
• Use RJ-45 male connector and connect it to the RJ-45 port of converter.
Appendix A lists the balanced connector pin assignment.
To connect the unbalanced interface:
1. Connect the receive line to the back panel connector designated TX.
2. Connect the transmit line to the back panel connector designated RX.
Do not connect both balanced and unbalanced connectors.
Connecting the T1 Line
T1 link interface terminates in balanced RJ-45 connector, marked LINK.
To connect the balanced interface:
•
Use RJ-45 male connector and connect it to the RJ-45 port of converter.
Appendix A lists the balanced connector pin assignment.
Connecting the DTE
Converters support V.35 and RS-530 data channel interfaces. The DTE equipment
can be connected directly to the RIC-E1 DTE port. Connector pin allocations and
cable wiring data appear in
Appendix A .
Connecting the Power
Refer to the appropriate section below depending on the unit’s version – AC or
DC.
Warning