Black Box MSC-120-CCN, Руководство пользователя

Страница: 20 / 28

877-877-2269 | blackbox.com
Page 20
Chapter 3: Configuration and Setup
3. Configuration and Setup
Remove and discard all packaging materials and then lock the lockable casters.
Open and inspect the Cabinet to verify all doors, locks, and casters are working properly.
Do not plug the Cabinet into a wall outlet until all configurations and setup are complete.
3.1 Routing the Cable (Applies to MSC-84, MSC-96, and MSC-192 Part Numbers, Cabinets with
Shelves sized for Tablets)
1. At the back of the Cabinet, loosen the two screws on the cable manager, pull up on the top section of the cable manager, and
place the device side of the charging cable into one of the slots. (See Figure 3-1.)
Cable
manager
Route cable to the
front of the cart
Loosen screws on cable manager
and pull up
Wrap excess cable
around cable wrap
Power
Strip
Charger
Figure 3-1. Cable routing inside the cabinet.
2. Replace the top section of the cable manager and tighten the screws.
3. Route the device side of the charging cable to the front of the cart and repeat step 1 for the front cable manager.
NOTE: The optional front cable management bars are included only with the MSC-84-TCN, MSC-96-TCN, and MSC-192-TCN.
4. Wrap any excess cable around the cable wrap on the back of the shelf.
5. Plug the charger power plug into the power strip located below the shelf.