Manual of VDSL2 Solution
http://www.black-box.eu
_____________________________________________________________________________
VDSL2
Channel Config
Lets you control the bandwidth passing across the Link.
(Factory Default is 64 kbps Minimum and 102400 kbps Maximum)
Also gives you the chance to set up Interleave. Higher Interleave values may give you a
more consistent latency.
(Factory Default is 1ms)
Line Config
Lets you configure the target SNR value for your Link that is acceptable. By lowering
that value you may get a link at a higher reach, but it will not be stable.
(Factory Default is 6 db)
Profile Config
Lets you configure the profile being used for your Link.
You can choose Profile, Band Plan, Filter and Tone Mode for the Transmitter.
You can choose Filter and Tone Mode for the Receiver.
Filter and Tone Mode of Transmitter and Receiver need to match.
(Factory Default for Filter is Off, for Tone Mode is V43)
The choosen Profile and Band Plan of the Transmitter are automatically
detected by the Receiver
The Profile and Band Plan tell the Modems which frequencies are being used and how
data is processed and transferred. The Filter and Tone Mode tells the modem
specialities about the line.
Optimal Setups:
Profile 30a, Annex C_8K, Filter Off and Tone Mode V43 for High Bandwidth
Profile 8d, Annex A M1_EU32, Filter Off and Tone Mode B43 for Long Distance
Bands Config
Let you configure special frequencies to be used.
Do not make any changes unless specifically advised by Black Box!
LoopBack
Enable LoopBack Functions for Testing
Users are not intended to use this function !
Activate Deactivate
Activate or Deactivate the Link
The Link needs to be activated on both sides to operate
LineStatus
For every Frequency section you can view the SNR values.
They should be positive and the higher, the better.
ChannelStatus
The Link performance
VersionInfo
Detailed Information about the software and hardware of MEG201AE
SNRGraph
Graphics showing you SNR values
BitsGraph
Graphics showing you where how much data is transferred.
