Manual of VDSL2 Solution
http://www.black-box.eu
_____________________________________________________________________________
You can use the Serial Interface to configure an IP address by this command:
ifconfig adm0 <ipadress> netmask <subnetmask>
(Example: ifconfig adm0 192.168.16.240 netmask 255.255.255.0)
This configuration is activated immediately but is only temporary because not stored in
flash memory. We recommend you continue configuring by Web method.
Other commands very useful:
rawaccess –e
(Factory
Default)
reboot
(RESET)
ping
(check connectivity to an IP address)
The Serial Bootmenu
Sometimes it may be necessary to use the Serial Bootmenu. Please check with Black
Box Tech Support before you attempting to do so.
While powering up the MEG201AE you can stop the boot process while this message is
displayed. Press SPACE three times to enter the boot menu then:
Press <space> key tree times to enter boot menu..
2
Loader Menu
==================================
[1] Xmodem Download
[2] TFTP Client Download
[3] Print Boot Params
[4] Set Boot Params
[5] Update bootloader
[6] Exit
Please enter your number:
Option 1 enables you to upgrade the firmware by RS232 with Xmodem. This is a very
slow but very secure upgrade method.
Option 2 enables you to upgrade the firmware by TFTP.
Option 3 will give you information about the device
Option 4 enables you to change CO/CPE status
Option 5 enables you to upgrade the bootloader
It is not recommended to use any of these options without consulting Black Box or
unless specifically instructed by Black Box tech support to do so.
