Manual of MEG101AE-R2 and MEG101RAE-R2
http://www.black-box.eu
_____________________________________________________________________________________________
______________________________________________________________________________
Installing the Modem
Hardware Installation
This chapter describes how to install the Modem and establish network
connections. You may install the Modem on any level surface ( e.g, a
table or shelf). However, please take note of the following minimum site
requirements before you begin. Stick the 4 plastic feet at the bottom to avoid
scratches.
Pre-installation Requirements
Before you start the actual hardware installation, make sure you can provide the
right operating environment, including power requirements, sufficient physical
space, and proximity to other network devices that are to be connected. Verify the
following installation requirements:
The standard power supply coming with MEG101AE-R2 and MEG101RAE-R2 is
intended for use in Central Europe only (220V). It supplies 5V@1A. For use in
USA, Japan, Australia and UK please use Black Box power supply PS649-R2 for
the Transmitter and the Receiver. PS649-R2/4 is available to power 4 of these
units with one power supply.
The Modem should be located in a cool dry place, with at least 10cm/4in of space
at the front and back for ventilation.
Place the Modem out of direct sunlight, and away from heat sources or areas with
a high amount of electromagnetic interference.
Check if network cables and connectors needed for installation are available
