12
SHORT-HAUL MODEM-B SYNC (SHM-B SYNC)
4. Installation
4.1 Installing Standalone Units
Take these steps to install a pair of standalone SHM-B
Sync units (ME801A or ME801A-E):
1. Open the case of one of the SHM-B Sync units.
Refer to
Chapter 3
for how to do this (and for
precautions you should take when you do).
2. Feed the 4-wire twisted-pair cable that will run
between your SHM-B Sync units through the
appropriate hole in the back of the case (refer to
Figure 3-1 on the previous page). Refer to
Appendix A
for maximum-length guidelines for
this cable.
3. Take the end of this cable and remove the outer
jacket and insulation from the last half-inch
(1.3 cm) or so of it, exposing the ends of the four
individual wires. Strip the insulation from the last
1
⁄
8
to
3
⁄
16
of an inch (0.3 to 0.5 cm) of each wire.
Содержание ME801-C
Страница 36: ...35 NOTES...
