Black Box MD3310-R2, Руководство пользователя

Страница: 23 / 50

20
INDUSTRIAL MODEM RF115
4. If you want to link to a different slave, this time without using a repeater,
reissue the ATXC# command, where # is either a position in the Call Book that
contains no repeaters or the letter A. When the command ATXCA is issued,
the modem is instructed to “Call All,” and no repeaters are used.
The Slave security may be disabled so that a modem operating as a slave (Modes 1,
4, and 6) will connect to any modem calling it regardless of whether the calling
modem is in the slave’s Call Book. This feature is necessary when there are more
than 10 modems that may call in to a slave and will allow any of the units in the
system to call in. An entry exists in the Edit Radio Characteristics Menu so that this
feature can be enabled or disabled.
Changing the User Interface settings in Mode 6
When in Mode 6, the settings in the modem’s user interface may be changed
directly without using the reset button. To do this:
1. Enter a new entry under Call Online Service (such as RF115 Setup).
2. Establish a hardware setup entry for the modem with the settings shown in
Table 5-3 on the next page.
3. Instruct pcANYWHERE to run a script file after connection (under advanced
Host PC settings). This script file should contain the following lines:
SEND STRING “ATXS”
END TERMINAL
When pcANYWHERE is instructed to call the entry corresponding to the modem
setup, it should go into Terminal mode and then display the modem user
interface. The LEDs on the modem will all be solid green, indicating setup mode.
Parameters in the menu may be modified as they normally would. When you’re
done with the setup menu, exit in the normal manner by pressing the escape key
until the LEDs change back to the Mode 6 state (or if you cannot see the LEDs,
simply press the escape key 2 or 3 times when in the Main Menu). The
pcANYWHERE terminal should then be closed and the session ended.
NOTE
If the modem user interface is not exited completely before the
pcANYWHERE session is ended, the modem will remain in setup mode.