SW161A Power Switch Maverick 1-Port User Guide
1. Safety instructions: To be read before use!
The Power Switch devices can only be installed by qualified people with the following
installation and use instructions. The manufacturer disclaims all responsibility in case of a
bad utilisation of the Power Switch devices and particularly any use with equipments that
may cause personal injury or material damage.
This equipment is designed to be installed on a dedicated circuit that must have a circuit
breaker or fuse protection.
The electrical power socket used to plug the power cord of the Power Switch devices must
be close to the Power Switch devices and easily accessible.
Check that the power cord, plug and socket are in good condition.
The Power Switch devices can only be connected to three-wire 230 VAC (50-60Hz) sockets.
Always plug the Power Switch devices into properly grounded power sockets (two poles plus
ground).
Never exceed 10 Amp total load.
If you have to replace an external fuse of an Power Switch device, never use another type of
fuse than 10A/250V T.
The Power Switch devices are intended for indoor use only. Do NOT install them in an area
where excessive moisture or heat is present.
Always disconnect the power cord of the Power Switch device if you want to intervene on the
Power Switch device or on the equipment powered from the Power Switch device.
The power outlet of the Power Switch device is not a circuit breakers! If you want to intervene
on equipment connected to an Power Switch device you must disconnect this equipment
from the Power Switch device.
The Power Switch devices contain potentially hazardous voltages. Do NOT attempt to
disassemble them.
The Power Switch devices contain no user serviceable parts and repairs are to be performed
by factory trained service personnel only.
